Foundation
The foundation (or footing) is the mechanical link between architecture and the planet. Its task sounds simple but is highly complex: it must carry the entire dead load of the building as well as all live loads (furniture, people, wind pressure) and distribute them into the subsoil in such a way that the house does not settle unevenly or even tip over. A poor foundation forgives nothing—cracks in the walls are often only the harbingers of a structural disaster.
The classics of shallow foundations
If the soil directly beneath the house is load-bearing enough, shallow foundations are used:
Strip foundation: The classic for walls. Concrete strips run exactly under the load-bearing walls. This saves material compared to a complete slab, but requires stable, uniform ground conditions.
Foundation slab (base slab): Here, the entire house rests on a continuous, reinforced concrete slab. This is the standard in residential construction today, since the load is distributed over an area—ideal for less load-bearing soils or when a basement is planned anyway.
Isolated foundation (pad footing): These are used where point loads occur, for example under supports of a warehouse, a carport, or a garden shed. They are compact concrete cubes set deep enough in the ground to avoid frost damage.
When it goes deeper: pile foundations
Sometimes the upper soil is "soft as butter" (e.g., near coasts or in moorland areas). Then the time for deep foundations has come. Here, long piles made of concrete, steel, or wood are driven, drilled, or vibrated so deep into the ground until they reach a load-bearing rock layer or find sufficient support through shaft friction. Skyscrapers and bridges are almost always built on such "stilts."
The "frost-free depth" — a critical detail
In Germany, a foundation generally has to extend at least 80 centimeters into the ground. Why? Because freezing water in the soil increases in volume. If the foundation were only near the surface, frost would literally lift the entire house and cause it to sink unevenly when thawing.
What is often underestimated in planning
A foundation is not a static component for eternity if environmental factors are not right:
Groundwater: Pressurized water can buoy up the slab like a boat or chemically attack the concrete.
Soil characteristics: Clay transfers loads differently than sand or rock. Without a geotechnical report, every foundation is a gamble.
Waterproofing: A foundation must not only bear loads but also seal. A defective horizontal barrier leads to rising damp in the masonry.
The foundation as the most important construction investment
The foundation is the only component that can practically no longer be corrected after completion of the structural shell. While a roof can be re-covered or a façade renovated, a faulty foundation is often the death sentence for a project's economic viability. Anyone who cuts corners on concrete or structural calculations here is literally building on sand. Intelligent foundation design is life insurance for every building. Further information for transparent repair documentation can be found at repair fair.