Soldering

Soldering is a thermal process for materially bonding metal parts. In contrast to welding, the workpieces themselves are not melted. Instead, a filler metal—solder—is used, whose melting point is below that of the base materials being joined. Through capillary action or flow, the liquid solder wets the surfaces, penetrates even the smallest gaps, and after solidifying forms a firm, electrically conductive connection.

The two worlds of soldering

Depending on the working temperature, workshops distinguish between two fundamental techniques:

  • Soft soldering (below $450^\circ\text{C}$): This is the standard process in electronics and building services. Tin alloys are mostly used. The joint is moderately load-bearing mechanically, but ideal for electrical contacts or leak-tight pipe connections.

  • Brazing (above $450^\circ\text{C}$): Silver- or brass-based fillers are typically used here. Because the temperatures are significantly higher, the resulting joint is considerably stronger and more heat-resistant. This technique is frequently found in goldsmithing or in high-end mechanical engineering.

The process: cleanliness as the top priority

For the liquid solder to form a chemical bond with the metal, the surface must be absolutely clean. Oxygen in the air immediately forms oxide layers that would prevent wetting.

  1. Cleaning: The soldering point must be mechanically cleaned (e.g., with fine sandpaper) of dirt and grease.

  2. Flux: This chemical substance (as a paste, liquid, or contained in the solder wire) dissolves existing oxides when heated and prevents new formation during the soldering process.

  3. Wetting: The heated workpiece causes the solder to melt. If the temperature is correct, the metal flows into the gap almost like water—a process that must be controlled as precisely as drawing a warp thread into a heddle.

[Image showing the capillary action of liquid solder in a pipe joint]

Tools and safety

Different heat sources are used depending on the task:

  • Soldering iron: For fine work on circuit boards, where heat is applied with pinpoint accuracy.

  • Soldering torch (gas): For larger components or brazing, where the entire workpiece must be brought to working temperature.

  • Safety: Since soldering produces fumes from the flux, good ventilation or extraction—similar to dust prevention in carpentry—is absolutely essential.

Repair and proper documentation

Cold solder joints or connections loosened by corrosion are a common cause of technical defects. Professional rework requires experience so as not to endanger the integrity of surrounding components through excessive heat. Specialists ensure that repaired connections regain their original conductivity and strength.

You can find out more about modern repair documentation at repair fair. Learn more in our knowledge portal about the latest topics in the skilled trades!